Tag Archives: light

How to replace the rear brake pads on my passat 2007?

Leave a reply

solved the problem, i found a TSB explaing what to do when this happens, and than i found a realy good HOW TO.

Practicly you need to reset the hand brake cylinder by:

1. Disconect batery for 5 minutes (this means if your car is 2007> you will have to go to dealer so he can put the code for radio thru some GEKO system othervise you cant use the radio!)

2. Connect the batery.

3. Dont start the car only give contact (many lights go on )

4. pres and hold the brake while presing the hand brake 2 times on and 2 times off. (i waited 30 seconds betven “on” and “off” cause the manual i found wasnt very clear)

5. Than i pussehd the cylinder back with hands, (Be carful not to turn it!!!) only push it straight i did it by hand.

6. Put everything back, deleted the fault codes and started all over again like manual said on the previous post.

I did everything like it said but at the end i end up with P on the dash light up, than i only deleted the fault codes from controler 53 – Hand brake and it worked like a charm!

How do you reset the “Maintenance Required” light on 2002 Accord

Leave a reply

1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the button.
4) After about 10-15 seconds, the light should go off.

How do you reset the "Maintenance Required" light on 2002 Accord

Leave a reply

1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the button.
4) After about 10-15 seconds, the light should go off.

Oil service light reset indicator Chevrolet Cobalt 2004-2010

Leave a reply

How do you reset maintenance light, reset service light indicator Chevrolet Cobalt 2004-2010. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Chevrolet Cobalt, oil reset instructions:

2005-2010

Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset the service light on your Chevy Cavalier

Leave a reply

Reset service light indicator, engine oil life Cadillac Cavalier, reset instructions:

1. Make sure the light is has a wrench icon. This article is not intended to help reset a “service engine” light.

2. Without turning on your car, turn the key to the right and you’ll see all of your dash lights come on.

3. Press on the brake 4 times. On the 4th time, hold the brake petal down for 30 seconds and release. This should reset the light.

4. Always always always contact your mechanic! This trick was told to me by my mechanic because I saw the light and took it in for servicing. I went to a non-dealer mechanic, but after they ran a diagnostic, they couldn’t find anything wrong. I called my GM mechanic and they suggested that if noting was found wrong, it was probably a light that needed to be reset. I plan to take it in for a tune-up soon but knowing that nothing serious was wrong was a nice weight off my shoulders and my wallet!