Tag Archives: RESET

Reset service light, maintance on Toyota Avensis

How can you reset service light, maintance on Toyota Avensis

1. Set the multi-information display to TRIP A.

2. Turn the ignition switch off.

3. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG).

4. After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.

Service light indicator reset Fiat Scudo

Reset service light indicator, engine oil life FIAT Scudo, oil reset instructions:

Think you press the trip bottom on the dash, whilst turning the ignition on, and hold it down for 10 seconds.

Service reset for 2007 Fiat Ducato

Reset service light indicator, engine oil life Fiat Ducato, year 2007, oil reset instructions:

Switch Ign on (do not start engine)
Set Odometer to read total miles.
Press Odometer Button (OB) until CFG1 appears in display
Release the OB.
Pressing the OB briefly will change between CFG1, CFG2, CFG3, CFG1
Once you have selected the CFG (see below).
Press the OB again for 5secs to store the new service frequency.
Turn off the ignition.

I selected CFG1 for my vehicle (05 Reg 2.8JTD), but you must decide yourself for your vehicle, should take 5mins to read this and carry out the resetting procedure

Note: If your vehicle is under warranty and you take it to be serviced by a Fiat dealer they will do this as part of the service.

CFG1 = 30000km (18,600mi) and 365 days in cases of Standard Use for 2.0 petrol and 2.8JTD versions, or in the case of Severe Use for the 2.3JTD versions.

CFG2 = 20000km (12,500mi) and 365 days in case of Standard Use for 2.0JTD versions, or in case of severe use for 2.0 petrol and 2.8JTD versions

CFG3 = 15000km (9,300mi) and 365 days in case of Severe Use for 2.0JTD versions

Reset oil service KIA forte 2010 oil mantainance light

Reset service light indicator, engine oil life KIA forte, year 2010, oil reset instructions:

u can change the oil after every 5000 miles

Reset the service light on a 2002 Rover 75

There are 3 stages
locate the obd plug and find pin 8 then
turn ignition to pos 2
with a fused wire ( a piece of wire with a fuse in it)
ground pin 8 for 4-5 seconds
turn ignition off
repeat this procedure 2 more times but for 8-12 seconds and then the service indicator will be reset.