Tag Archives: reset service

Turn Off an Oil Light on a 2005 KIA Spectra

Leave a reply

Instructions

1. Pull the vehicle over to a safe area, if the light comes on while driving. If you are very close to a store that sells motor oil, stop there. Do not continue driving with the indicator light lit, as severe engine damage may occur.

2. Turn off the vehicle’s engine and open the hood. Locate the oil filler cap and oil dipstick on the top-front of the engine.

3. Check the engine oil level on the oil dipstick. If the engine oil is low, remove the oil cap and add oil until the oil level on the oil dipstick reaches the “Full” mark.

4. Replace the oil cap and restart the Kia. The oil light should turn off within a few seconds of starting the vehicle.

Reset oil service KIA forte 2010 oil mantainance light

Leave a reply

Reset service light indicator, engine oil life KIA forte, year 2010, oil reset instructions:

u can change the oil after every 5000 miles

Oil service light reset indicator Bentley Continental Fluying Spur

Leave a reply

Reset service interval display, insp and oil service for Bentley Continental Fluying Spur, 2004, that can be made manually by use button on car dashboard.

Reset service light indicator, engine oil life Bentley Continental Fluying Spur, year 2004- oil reset instructions:

The real repair is to have the vehicle serviced by a Bentley dealer. The other option is as follows…
Press and hold the trip button
While doing this, turn the ignition key into the on position
Let go of both, and you will see the words “service reset” on the drivers instrument panel screen
Now press the silver knurled roller switch “OK” on the right side of the steering wheel controls, by the menu button. This will confirm the request.

Service light reset indicator for BMW X5 2002

Leave a reply

Reset service light indicator, engine oil life BMW X5 year 2002 reset instructions:

BMW X5 Engine Oil Service reset

Turn the ignition to “0”
Press and hold odometer button and turn the ignition to “1”.
Hold odometer button pressed for approximately 5 seconds until the display shows: “Inspektion Re /
Release and press odometer button again until Reset flashes
Release and press odometer button shortly.
Release and press odometer button again.
The next oil service interval will be shown and will disappear.
Oil service lamp is now reset

Note: To abort the procedure at any time: turn the ignition to “0”.

Reset the Range Rover Airbag Fault Code

Leave a reply

Instructions

1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.

2. Slide the clamp off of the negative battery terminal.

3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.

4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.