1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the button.
4) After about 10-15 seconds, the light should go off.
How do you reset maintenance light, reset service light indicator Chevrolet Cobalt 2004-2010. For reset maintenance light and that can be made manually by use button on car dash board.
Reset service light indicator, engine oil life Chevrolet Cobalt, oil reset instructions:
2005-2010
Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.
I second that, as I was shown how to do it. Follow it, VEry simple instructions.
Have your key in the ignition, but off. Well make sure its at trip A before you start this.
Next, press the button, but leave it pressed….
Now put the car into the “on” position….
The indicator will show a bar like it was counting down, wait till that finishes and it all starts to show 0000miles or whatever it is. And let go.
Your done.
Reset service light indicator, engine oil life Volkswagen Crafter 2.5 td, reset instructions:
VW Crafter service reset Sitting in the drivers seat looking at the dash on the left hand side you have a M button and below it a 0 button these are the buttons you will need to use.
When i refer to the LCD this is the illuminated part in the middle that shows your mileage,service mileage and trip mileage.
Please read this fully first to get the jist of it as if you perform the actions too slow it wont work and you will have to start over.
1.Put on ignition
2.Wait for service mileage to revert to vehicle mileage
3.When it reverts to the vehicle mileage press and hold the 0 button until you hear a beep (can take up to 30 seconds)
4.As soon as you hear the beep press the M button repeatdly and you will see in the LCD display different reset’s the one you need to select is “reset 51” if you go past it just keep pressing the M button till it comes up again.
5.When the “reset 51” is displayed stop pressing the M button then press and hold the 0 button again until a number 2 is displayed in the LCD.
6.Release the 0 button and then press twice and it will say in the LCD reset done ,if it is not reset you will get a 30% power reduction after 2K miles
Reset service light indicator, engine oil life Ford Galaxy, reset instructions:
With the ignition off, press the reset button under the mileage counter
Hold in reset button whilst turning the ignition on
After about 4 or 5 seconds (up to 30 seconds in some cases) the display should reset itself
Release the button and turn the ignition off
It may be necessary to repeat this process