Tag Archives: position

Oil service light reset indicator Chevrolet Cobalt 2004-2010

Leave a reply

How do you reset maintenance light, reset service light indicator Chevrolet Cobalt 2004-2010. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Chevrolet Cobalt, oil reset instructions:

2005-2010

Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Reset service light toyota yaris

Leave a reply

I second that, as I was shown how to do it. Follow it, VEry simple instructions.

Have your key in the ignition, but off. Well make sure its at trip A before you start this.

Next, press the button, but leave it pressed….
Now put the car into the “on” position….
The indicator will show a bar like it was counting down, wait till that finishes and it all starts to show 0000miles or whatever it is. And let go.

Your done.

How to Reset the “MAINT REQD” Light on Toyota Sienna

Leave a reply

1. With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B).
2.Turn the car off (ignition key to the OFF position).
3. Push in AND HOLD the button/knob that switches the odometer
4. Turn key to ON position without starting the car. You will notice the maintenance light blink and go out.
5. Release the odometer button/knob.
6. Turn key to OFF position.
That’s it! The “MAINT REQD” light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.

How to Reset the "MAINT REQD" Light on Toyota Sienna

Leave a reply

1. With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B).
2.Turn the car off (ignition key to the OFF position).
3. Push in AND HOLD the button/knob that switches the odometer
4. Turn key to ON position without starting the car. You will notice the maintenance light blink and go out.
5. Release the odometer button/knob.
6. Turn key to OFF position.
That’s it! The “MAINT REQD” light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.

Service light reset oil indicator for Audi A3

Leave a reply

Reset service light indicator, engine oil life Audi A3, year 2003-2009 oil reset instructions:

For Fixed Interval servicing, you can use the following procedure:
Start with the ignition turned ON (position 2), but with the engine OFF
Pull out and hold the button on the right side of the display until “SERVICE” appears on the display
Release the button on the right, then within 5 seconds pull the button out and hold it again
Release the button when the display shows “- – -” or “SERVICE IN xxxx Miles / Kilometres, xxxx days”
Turn off the ignition