Tag Archives: OIL LIGHT RESET

How to Reset the Service Light on a Jeep

Leave a reply

Instructions

Things You’ll Need
Wrench
Ignition key
OBDl or ll scanner

1. Disconnect your battery cables from the battery posts with a 6-pt. closed wrench in the size appropriate for the battery bolts. Remove the negative (black) cable first. Leave the battery disconnected for several minutes, according to Allpar.com. Reconnect, this time starting with the positive cable, and crank the engine. The code should be gone.

2. Crank the Jeep. Drive it forward, then backwards, and shut off. Repeat this procedure three times. The codes should clear on the fourth crank.

3. Use a OBDl or OBDll scan tool. Plug the tool into your Jeep’s ALDL (Assembly Line Diagnostic Link), a small, rectangular electrical port usually located under the dash. Turn the key to the “on” position. Scan the computer for codes and select the option to clear the codes.

4. Wait for the code to clear itself automatically. Once the component is fixed, the check engine light disappears after several successful ignitions. The code is then stored for a while. If the engine continues to start and run without a re-occurrence of the original problem, the code is wiped out.

Oil service light reset indicator Chevrolet Cobalt 2004-2010

Leave a reply

How do you reset maintenance light, reset service light indicator Chevrolet Cobalt 2004-2010. For reset maintenance light and that can be made manually by use button on car dash board.

Reset service light indicator, engine oil life Chevrolet Cobalt, oil reset instructions:

2005-2010

Turn the ignition to run (one position before starting engine).
Press the INFORMATION and RESET buttons on the DIC at the same time to enter the personalization menu.
Press the INFORMATION button to scroll through the menu until OIL LIFE RESET is displayed.
Press and hold the RESET button until the DIC display shows ACKNOWLEDGED. This will tell you the system has been reset.
Turn the ignition off and then start the engine to verify the indicator has been reset.

Reset service light 2000 seat ibiza

Leave a reply

Vehicles on fixed interval servicing can be reset as follows
Press and hold button “A” (positioned right of trip recorder display)
Switch ignition ON
The word “SERVICE” will appear in the trip recorder display
Release button “A”
Turn button “B” (positioned left of trip recorder display) to the right to reset the display
Switch ignition OFF

This applies to fixed service intervals only appearently

Button “A” is the trip reset
Button “B” is the clock set

Reset service light 2007 seat leon

Leave a reply

Service light reset is as follows:-

1. Press and Hold the Odometer knob in
2. Turn the ignition on (do not start the car though)
3. Turn the odometer knob to the right and hold for about 5 secs.
4. Release odometer knob and switch ignition off.
5. Start car, Service indicator should now be gone.== Answer ==
cheers for the info worked first time probably saved me a few quid putting the car to a dealers.
ta much!

this worked on a 2000 modal with out a problem

Reset service indicator citroen piccaso

Leave a reply

Reset service light indicator, engine oil life citroen piccaso reset instructions:

To reset the service light on your vehicle is a straight forward procedure. Ignition off , Hold down the left dash button with the 000 s on . Whilst holding the button turn on the ignition and watch the display count down to 0 . Turn ignition off then on again and there you have it. Magic. Obviously this should be done in conjunction with a routine service to insure your car is safe reliable and legal .