1. Turn the ignition to run (one position before starting engine).
2. Ensure odometer reading is shown, turn ignition off.
3. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
4. Hold down knob for at least 5 seconds. The odometer indicates “000000″ and the light goes off. If the system fails to reset, the light will continue flashing.
5. Turn the ignition off and then start the engine to verify the indicator has been reset.
How do you reset maintenance light, reset service light indicator Fiat Stilo. For reset maintenance light and that can be made manually by use button on car dash board.
Reset service light indicator, engine oil life Fiat Stilo, oil reset instructions:
1) Ensure ignition key is turned off.
2) Press and hold the odometer reset button whilst turning the ignition switch to the on position.
3) Keep the odometer reset button pressed for 10 seconds whilst the service display counts down from 10 to 0. When the count down reaches zero the spanner icon will vanish from the display and the service indicator will be reset.
Instructions
1. Pull the vehicle over to a safe area, if the light comes on while driving. If you are very close to a store that sells motor oil, stop there. Do not continue driving with the indicator light lit, as severe engine damage may occur.
2. Turn off the vehicle’s engine and open the hood. Locate the oil filler cap and oil dipstick on the top-front of the engine.
3. Check the engine oil level on the oil dipstick. If the engine oil is low, remove the oil cap and add oil until the oil level on the oil dipstick reaches the “Full” mark.
4. Replace the oil cap and restart the Kia. The oil light should turn off within a few seconds of starting the vehicle.
Reset service light indicator, engine oil life KIA forte, year 2010, oil reset instructions:
u can change the oil after every 5000 miles
Instructions
1. Open the hood and loosen the retaining nut on the cable clamp running to the negative battery terminal.
2. Slide the clamp off of the negative battery terminal.
3. Wait 1 minute for the Range Rover’s electronic control module to cycle and reset. Then, reconnect the clamp to the negative battery terminal.
4. Tighten the retaining nut on the cable clamp. The airbag light should go out at this point. When it does, you’ll know that the fault code has been erased.