Instructions
1. Push inward on the trip odometer reset button and turn the key to the auxiliary position (forward one click from the off position) until “Oil Service Re” or “Oil Service Reset” appears on the odometer screen.
2. Press the odometer reset button a second time until the work “Reset” or “Re” appears on the screen. The word will continuously flash.
3. Press the odometer reset button quickly to complete the reset. “End SIA” appears to indicate a successful reset of the system.
Resetting Oil Service Light on your 2002 – 2006 Cooper and Cooper S Hatchbacks, and 2005 – 2008 Cooper and Cooper S Convertibles:
1) Press and hold the trip button
2) Insert key and turn to position 1
3) Watch for RESET to appear
4) Release the button, then press & hold it again
5) Wait for the RESET to flash
6) Release the button, and then press & release (once only)
7) Service interval should then be reset to next interval
If that didn’t work, try this:
1. Push the Trip Button
2. Turn ignition key to position 1 and 51A will appear to left of mileage
3. Release trip button
4. Wait 3 seconds
5. Push trip button
6. Wait (5-8 seconds) for RST to appear in left corner
7. Release trip button
8. Push trip button
9. 15000 will appear as new service interval
10. Release trip button
Or this:
1. Press and hold the trip odometer button.
2. Insert car key and turn it to the fi rst position (not the second position).
3. You will see 51A come up in the trip odometer area.
4. Release, then press and hold again.
5. Watch for the word “RST” to appear on the Odometer indicator.
6. Release, then press and hold again.
7. Wait for the “RST” message to fl ash.
8. Release, and then press & release (once only).
On my ’08 I just had the oil change indicator come on, and I successfully reset it. The point is that the message took a few seconds after turning the key on to appear in the dash. You need to wait until the message appears, then you have 10 seconds to do the 3 pedal depresses. It doesn’t work if you start depressing the pedal immediately after turning the key on, if you don’t wait for the oil change message to appear.
How do you reset maintenance light, reset service light indicator Jaguar S-type. For reset maintenance light and that can be made manually by use button on car dash board.
Reset service light indicator, engine oil life Jaguar S-type, oil reset instructions:
Here’s how to do it yourself in no time works on a few different Jags….
Service Light Reset Instructions:
1 . Insert key into ignition.
2 . Press and hold the Reset switch (located on the Trip Computer Switchpack ).
3 . NOTE: The reset switch has to be released immediately after the ignition is switched ‘ON’. This is critical to enable the rest of the procedure.
Turn the key to Ignition position II and at the point of entering Ignition position II (i.e when a click is heard), instantaneously release the Reset switch.
4 . Wait one second.
5 . Press and hold the Trip switch (located on the end of the left-hand side stalk).
6 . Wait one second.
7 . Press and hold the Reset switch (whilst still holding the Trip switch).
8 . The cluster should display (within three seconds) the warning message ‘RESETTING SERVICE MODE’.
9 . Keep both buttons pressed until the warning message changes to ‘SERVICE MODE RESET’ (after ten seconds).
10 . Once the message is displayed the buttons may be released — sequence is now complete.
11 . If a Service Required message was displayed prior to the reset sequence, cycle the ignition to ‘Off’ and then back to Ignition position II and check that the message is no longer displayed.
Reset service light indicator, engine oil life Volkswagen Tiguan, year 2009-2010 reset instructions:
Manual Reset:
Turn the ignition to run (one position before starting engine).
Press and HOLD the trip-odometer button “0.0”.
Turn your key to run (one position before starting engine).
Release the trip-odometer button.
Push and release the Clock Minute Set Button “min”.
Turn the ignition off and then start the engine to verify the indicator has been reset.