Tag Archives: service reminder

Reset automatic transmission fluid temperature warning light Toyota Tacoma

Leave a reply

How to reset automatic transmission fluid temperature warning light Toyota Tacoma 2 generation.

Reset automatic transmission fluid temperature warning light Toyota Tacoma second generation. From year: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

Automatic transmission fluid temperature warning light four−wheel drive models only.

This light warns that the automatic transmission fluid temperature is too high.

To reset automatic transmission fluid temperature warning light on a Toyota Tacoma you must you must follow these steps: if this light comes on while you are driving, slow down and pull off the road. Stop the vehicle at a safe place and put the selector lever in “P”. With the engine idling, wait until the light goes off. If the light goes off, you may start the vehicle again. If the light does not go off, call a Toyota dealer or qualified repair shop for assistance.

Continued driving with the warning light on may damage the automatic transmission.

That it is the full procedure how to reset automatic transmission fluid temperature warning light Toyota Tacoma second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

Reset low windshield washer fluid level warning light Toyota Solara

Leave a reply

Reset low windshield washer fluid level warning light Toyota Solara second generation. From year: 2004, 2005, 2006, 2007, 2008.

How to reset low windshield washer fluid level warning light Toyota Solara 2 generation.

The light warns that the windshield washer fluid level is too low. Add washer fluid at your earliest opportunity.

Adding washer fluid.

If any washer does not work or the low windshield washer fluid level warning light comes on, the washer tank may be empty. Add washer fluid. You may use plain water as washer fluid. However, in cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. This product is available at your Toyota dealer and most auto parts stores. Follow the manufacturer’s directions for how much to mix with water.

Do not use engine antifreeze or any other substitute because it may damage your vehicle’s paint.

If the low windshield washer fluid level warning light is not gone means that a sensor is broken.

All information how can tou reset low windshield washer fluid level warning light is taken from Toyota Solara ownes manual.

That it is the full procedure how to reset low windshield washer fluid level warning light Toyota Solara second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

How to check service reminder light Toyota Solara 2 generation

Leave a reply

How to check service reminder light Toyota Solara 2 generation. From year: 2004, 2005, 2006, 2007, 2008.

How can you check service reminder light Toyota Solara second generation.

CHECKING SERVICE REMINDER INDICATORS except the low fuel level warning light and low windshield washer fluid level warning ligh).

  1. Apply the parking brake.
  2. Open one of the doors. The open door warning light should come on.
  3. Close the door. The open door warning light should go off.
  4. Turn the ignition key to “ON”, but do not start the engine. All the service reminder indicators except the open door warning light should come on. The “ABS”, “VSC” and low tire pressure warning lights, engine oil replacement reminder light, “TRAC OFF” and slip indicator lights go off after a few seconds. The SRS warning light goes off after about 6 seconds.

If any service reminder indicator or warning buzzer does not function as described above, have it checked by your Toyota dealer as soon as possible.

All information how to check service reminder light is taken from Toyota Solara 2 generation owners manual.

That it is the full procedure how to check service reminder light Toyota Solara 2 generation Toyota Solara second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

Reset oil service light Toyota Tacoma second generation

Leave a reply

Reset oil service light Toyota Tacoma second generation. From year: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

How to reset maint reqd service light Toyota Tacoma 2 generation.

Reset-oil-service-light-Toyota-Tacoma-second-generation.

Engine Oil Replacement Reminder Light (for vehicles sold in U.S.A.).

This light acts as a reminder to replace the engine oil. This light will come on when the ignition key is turned to “ON” and will go off after about a few seconds. When you drive for about 7200 km (4500 miles) after the engine oil replacement, this light illuminates for about 3 seconds and then flashes for about 12 seconds with the ignition key turned to the “ON” position. If you continue driving without replacing the engine oil, and if the distance driven exceeds 8000 km (5000 miles), the light will come on after the ignition key is turned to “ON” position. The light will remain on thereafter.

If the light is flashing, we recommend that you replace the engine oil at an early opportunity depending on the driving and road conditions. If the light comes on, replace it as soon as possible. The system must be reset after the engine oil replacement. Reset the system by the following procedure:

  1. Turn the ignition key to the “OFF” position with the odometer reading shown. For details, see “Odometer and two trip meters” in this category.
  2. Turn the ignition key to the “ON” position while holding down the trip meter reset knob. See below picture.
  3. How-to-reset-maint-reqd-service-light-Toyota-Tacoma-2-generation.
  4. Hold down the knob for at least 5 seconds. The odometer indicates “000000” and the light goes off.

If the system fails to reset, the light will continue flashing.

All information how can you reset oil service light is taken from Toyota Tacoma second generation owners manual.

 

That it is the full procedure how to reset oil service light Toyota Tacoma second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.

This is an information site where you can solve your car problems. Send us a comment if our procedures are correctly. If you would have anything to add, for us every opinion counts.

Reset seat belt reminder light Toyota Tacoma second generation

Leave a reply

Reset seat belt reminder light Toyota Tacoma second generation. From year: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014.

How to reset seat belt reminder light Toyota Tacoma 2 generation.

Driver’s seat belt reminder light and buzzer.

The light and buzzer act as a reminder to buckle up the driver’s seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes and buzzer sounds if the driver’s seat belt is not fastened. Unless the driver fastens the belt, the light continues flashing and the buzzer stops after about 4 to 8 seconds.

Front passenger’s seat belt reminder light.

The light acts as a reminder to have the front passenger buckle up the seat belt. Once the ignition key is turned to “ON” or “START”, the reminder light flashes if a passenger sits in the front passenger seat and does not fasten the seat belt. If luggage or other load is placed on the front passenger seat, depending on its weight, the reminder light may flash.

All information how can you reset seat belt reminder light is taken from Toyota Tacoma second generation owners manual.

That it is the full procedure how to reset seat belt reminder light Toyota Tacoma second generation. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Toyota cars. Or any warning light for service reminder which appears on the display. Write in the search box the car name for which you want to find information, and find how to reset other service reminders by yourself.